Standard
Features
-
1/4"
Plate Steel Exterior A-36 exterior / 2" kiln dried hardwood /
insulation / and a 5/8" finished plywood interior
-
Hardened
high security door, with A-36 HRS pins for hinge side protection
-
NAPEC
high security hasps and cam closure for weather tight seal.
-
Interior
Dutch Door with Day/Issue Port
-
Door
water trap
-
VCT
Floor Tile
-
All
conduit runs and make-up boxes for IDS system
-
Exterior
electrical service entrance, IDS service entrance, telephone enclosure
-
HVAC
system with Vent Hardening
-
Roof
Lifting Lugs and tie-down rings
-
All
associated electrical devices and exterior/interior lighting
-
NFPA
grounding kit, grounding lugs and grounding rods (two each per item)
The
armory is activated by an electrical connection to the load center and
ground rod installation by the customer.
Optional
accessories are available upon request for customers meeting specific
requirements. Including:
- Humidity
Control by means of a commercial grade dehumidifier with plenum works
(it is suggested that arms and ammunition be stored in an environment
no greater than 40% relative humidity).
- Weapons
Racks, Storage Cabinets, Ammunition Storage Cabinets and Personnel Desk
- High
density mobile aisle systems
- Furnishing
and wiring of the IDS system
- Work
Benches and Weapons Maintenance Bench
- Smoke
Alarm with exterior horn/strobe
- Dry
Chemical Fire Suppression System / Wet Sprinkler System
- weapons
clearing barrel system,exterior mounted only
- Interior
Cage Partition Walls with locked access door
- Secondary
entrance/exit door
- Increased
insulation for heating/cooling systems (standard Armory insulation is
R4; we suggest using no less than R12)
- Ramps
- Back-up
Emergency Lighting for interior and exterior service
- Non-standard
voltage systems (standard is 120V/1/60)
- Toilet
facility(usually furnished only in duplex armories
- Lighting
package (roof grid system, air terminals and four corner downward
connector)
- Special
bullet-resistant requirements
- Freight,
Crane, Rigging and Installation
Pre-fabricated /
Pre-engineered
portable self contained field armories are constructed to be
fire-resistant, weather-resistant and theft-resistant. These armories
are designed to store small arms and ready for issue small arms
ammunition. These armories meet or exceed DOD NSWC 3046-93-2 standards.
|
